Neues Projekt Hilfe?
  • Projekte
  • Zeitraum
  • Badge
Neueste Kommentare
LucDB
LucDB vor 2 Stunden
Thank you Rainer! What would be the maximum useable frequency? I am looking for an electronic load for Model Train boosters (DCC - 5~8 KHz). Thank you for your reaction, Luc
Electronic load for DC and AC
Sebelec
Sebelec vor 16 Stunden
Here is the software with a file which can be used to estimated the temperature measured by the NTC.
ATX powersupply for RPI
Raabinator
Raabinator vor 1 Tag
Software and gerbers uploaded today. Also added a brief manual in the comments.
Clock-In-A-Tube
Raabinator
Raabinator vor 1 Tag
Today I uploaded the current Software. Here is a brief description of how to operate it. After powering up and showing the SW-Version the device is in clock-mode. Clock-Mode Twisting the cork up toggles between hour and minutes or seconds display. Twisting down changes brightness in four levels. Holding the cork up for two seconds changes into setup mode. Setup-Mode Here you can set the current time and time correction per day. The element, that is currently to change is blinking. Twisting down increases the value. At the maximum the value wraps around to the minimum. Holding down chages the value faster. Twisting up changes the edited element. First is minutes, second is hours and third is correction seconds per day. After leaving the last element the time is saved to the PCF with seconds set to zero. Time Correction Because the crystal is not absoluetly correct, and i didn't want to use a trimmer, the time must be corrected to keep the deviation limited. The time correction value has a range from -30 to +30 seconds per day. When the unit is powered this correction is applied each day at 1am. When it is not powered, the time is corrected when the unit is next connected to a supply. The unit keeps track of the days to correct in the date-part of the PCF8563. This can easily be used because the date is not displayed. After the correction the date is set to zero. Each elapsed day the date is increased, actually when not connected to power. So, several days without power can be corrected. How to correct time At one day, you set the time of the device exactly to the time of a known source (ntp?). The next day at the same time, you check the runaway seconds of the device compared to the source. If the device is 5 seconds ahead, set the correction to -5 seconds. To be more accurate you can wait several days an divide the deviation by the days elapsed. This is easier then to fiddle around with a trimmer cap.  
Clock-In-A-Tube
fishbeetle
fishbeetle vor 2 Tagen
It can be used without PoE but there are plenty of other products readily available that would perform the UPS function. I believe the pdf documentation file above should answer your questions.  
Poe UPS Pi